Low profile handguard cover for BRN-180 upper receivers (16" barrel length handguards only) utilizing AKB-23 bullpup conversions. Tight and rigid connection via slip fit and four M-Lok mounting points. Clears OTB muzzle devices/suppressors. (Note: The tan cover pictured is a prototype and is not full length)
SLS PA-12 Nylon
Installation:
- Ensure M-Lok t nuts are inserted fully into the inside of the handguard cover.
- Back out the screws until they are flush with the face of the t nut.
- Slide the assembly over your handguard and into position.
- Now push the screws in to insert t nuts into M-lok slots (The front t nut will clamp the front of your handguard outside of the mlok slot).
